Section 5 Material Settings Guide. Damage to the laser system from this type of abuse ARE NOT covered under warranty. Setting parameters, and using different techniques to provide the best laser cutting and engraving results. If your system is equipped with two lasers, total the power of the two lasers. Jul 26, 2010 - Abstract Carbon dioxide (CO2) laser ablative fractional resurfacing produces. The preset operating parameters for fractional resur- facing are.
. 166 Downloads.Abstract.The production of single-walled carbon nanotubes (SWNTs) using the cw CO 2-laser ablation technique is reported. Different metals and metal concentrations in the carbon targets as well as different buffer gases and gas pressures have been used in order to study their influence on the formation of SWNTs. It is shown that the conditions near the evaporation zone, i.e. Especially the local temperature environment induced by the laser radiation as well as the used metals play a key role in the formation process of SWNTs. Employing a very simple experimental setup the cw CO 2-laser ablation technique easily provides the environment favorable for the growth of high quality SWNT material under a wide range of experimental conditions.